Cp-electronics EBDSPIR-PRM Manuel d'utilisateur télécharger pdf

page

1. Dimensions

Section Contents Page

1 Dimensional information 1

2 Description and operation 2

3 Wiring and fixing 3

4 Programming 6

Detection diagram

Fault finding

Specification

Part numbers

Contents

PIR Presence/Absence Detector

Product Guide

EBDSPIR-PRM

1 2 3 4 5 6 7 8

page 1. Dimensions Section Contents Page 1 Dimensional information 1 2 Description and operation 2 3 Wiring and fixing 3 4 Programming

Page 2

page 2 The EBDSPIR-PRM PIR (passive infrared) detector provides automatic control of lighting loads with optional manual control. It can be used on i

page 3 3. Wiring & Fixing 1. Wire the products using the diagram opposite. 2. To switch from more than one position simply wire two or more

page 4 FLUSH FIXING SURFACE FIXING 1 2 2 1 Hole Ø64mm Warning - be careful bending springs when mounting unit. Pull out spring tab and rotate spring

Page 5

page 5 3 5 3 4 5 4 6

page 6 4. Programming All the following functions can be programmed using the remote control DD-LCDHS handset: 1. Detector Parameters (factory d

page 7 5. Detection Diagram 6. Fault Finding LOAD DOES NOT COME ON Check to see if the live supply to the circuit is good. Strap across the L an

page 8 LOAD 10A of lighting and or ventilation including incandescent, fluorescent, compact fluorescent, low voltage (switch primary of transformer).

Modèles reliés EBDSPIR-PRM-VFC | EBDSPIR-PRM-VFC-LV | EBDSPIR-PRM-IP | MWS6-PRM-VFC |

Pas de commentaire